Puffs, Well, at least you now have a clear idea of the cause. The piston on my MZ150 has very sunken pins which makes it tricky to keep the rings located correctly when lowering the barrel. However I assumed that once inside the cylinder they would be adequate to stop the rings turning. So far, so good, but you have given me something else to worry about. As you have said previously, if the worst happens it will not be as expensive a fix as for you!
I believe its the original MZ piston.
MZ/MuZ Riders
A community for owners and riders or MZ Motorcycles, Scooters, and ATVs.
New TS250 Owner
Moderators: DAVID THOMPSON, 125SMash, phlat65
48 posts
• Page 4 of 4 • 1, 2, 3, 4
Re: New TS250 Owner
by dave47 » Wed Apr 13, 2022 6:23 am
- dave47
- Posts: 173
- Joined: Sat Apr 27, 2019 11:56 am
Re: New TS250 Owner
by Puffs » Wed Apr 13, 2022 6:31 am
Following a biased and flawed moderator choice (someone posting aggressive personal attacks is rewarded, while my technical posts are removed - behind my back & without any justification!), I have withdrawn from this forum.
Last edited by Puffs on Thu Apr 06, 2023 4:07 am, edited 2 times in total.
-
Puffs - Posts: 2007
- Joined: Tue Jan 16, 2018 11:20 am
- Location: Ardennes, Belgium.
Re: New TS250 Owner
by Puffs » Wed May 18, 2022 3:13 am
Following a biased and flawed moderator choice (someone posting aggressive personal attacks is rewarded, while my technical posts are removed - behind my back & without any justification!), I have withdrawn from this forum.
-
Puffs - Posts: 2007
- Joined: Tue Jan 16, 2018 11:20 am
- Location: Ardennes, Belgium.
48 posts
• Page 4 of 4 • 1, 2, 3, 4
Who is online
Users browsing this forum: No registered users and 53 guests