MZ/MuZ Riders

I need to replace both discs and have been finding it a bit of a struggle identifying replacements. Can anyone help?

the ebc catalog stinks any more finding this took over 2 hours and did not allow me to cut and paste
MD855x and MD855xc 320 mm dia fits no other bike i could find it is a floating rotor

page 640 in the 2017 ebc big book over 800 pages in my pdf reader its page 642
dave

When you find the correct type can you post it here please?
I thought I had it on my list of compatible bits but I don't, sorry.

this is so rare it will probably be hard to find even if you know the numbers

It looks very similar to a Yamaha SZR660 disc. Check the offset............

https://www.s3performance.com.au/front- ... SS7591.E20

Found this on the EBC site.

https://ebcbrakesdirect.com/motorcycle/ ... 2007/34668

Or this.

http://www.speedaddicts.com/motorcycle/ ... tor-md855x

From what I can find it's an MZ only fit but MandP in south wales lists it as the same disk as a Kawasaki GPZ 660r, GTR 1000 and GPZ 750. I cannot believe that MZ has a disk that is specific to them and didn't use a already available disk (as it did for everything else). Kawasaki disks will certainly be cheaper (as long as they fit). Good luck with your search, If I find out anything more I will let you know.

MJ310 wrote:Or this.

http://www.speedaddicts.com/motorcycle/ ... tor-md855x

From what I can find it's an MZ only fit but MandP in south wales lists it as the same disk as a Kawasaki GPZ 660r, GTR 1000 and GPZ 750. I cannot believe that MZ has a disk that is specific to them and didn't use a already available disk (as it did for everything else). Kawasaki disks will certainly be cheaper (as long as they fit). Good luck with your search, If I find out anything more I will let you know.

I noticed these too but they only have 5 mounting holes

who was i chatting to in abergavenny yesterday ?

dandywarhol wrote:

MJ310 wrote:Or this.

http://www.speedaddicts.com/motorcycle/ ... tor-md855x

From what I can find it's an MZ only fit but MandP in south wales lists it as the same disk as a Kawasaki GPZ 660r, GTR 1000 and GPZ 750. I cannot believe that MZ has a disk that is specific to them and didn't use a already available disk (as it did for everything else). Kawasaki disks will certainly be cheaper (as long as they fit). Good luck with your search, If I find out anything more I will let you know.

I noticed these too but they only have 5 mounting holes

I think that's just a generic picture because the part number is correct, MD855e and ex. I emailed ebc yesterday and got the full spec of the disks and they confirm that is the MZ1000 series is the only fitment for that disk. Below is the reply I got from EBC.



We will have discs with similar measurements but not exactly the same.

Kind regards
Mike Cooper
Data & Technical Adviser
01604 583344




From: Mick Johnston [mailto:mjgt01@gmail.com]
Sent: 09 October 2017 14:58
To: Mike Cooper
Subject: RE: General enquiry from EBC Brakes Direct

Thank you very much, are there any other disks with the same spec?

Cheers
Mick

On 9 Oct 2017 2:53 p.m., "Mike Cooper" <Mike.Cooper@ebcbrakesuk.com> wrote:
Hello the offset for this disc is zero-
Products
Prefix Part No Type heat treated OD Finished Thickness ID Off set bolt hole PCD No of bolt holes bolt hole dia Hole condition Rotor Variants Pattern
MD 0855 Floater Yes 320 5 64.2 0 80 6 8.5 Plain

If this is not correct we may have other options available if you can provide me with the dimensions shown above but please note we do not make one off specials.

handsomejackuk wrote:who was i chatting to in abergavenny yesterday ?

It was me, nice to have met you.

MD855x does fit.

I tried them.

Kind regards