Mikuni intake manifold

[Robmzetz]

Hi. I hope you knowledgeable lot can shed a little light for me. I have bought a mikuni vm30 carb to replace my tired bing. The inlet manifold is clamped by the carb inlet whereas the mikuni is clamped by the inlet. My. Question is will the original inlet manifold which I believe was for a bvf carb fit the mikuni and if so any advice on where to find one in the UK would be greatly appreciated. Many thanks. Rob.

[Puffs]

Following a biased and flawed moderator choice (someone posting aggressive personal attacks is rewarded, while my technical posts are removed - behind my back & without any justification!), I have withdrawn from this forum.

[Robmzetz]

Many thanks for the reply Puffs. Sorry it took me so long. I'm a technophobe. I got a standard inlet manifold and followed the instructions on an article I found. No problem at all. Thanks again.