Rear wheel removal?

Vehicles equipped with the 500 cc Rotax engine

Moderators: DAVID THOMPSON, phlat65

Rear wheel removal?

Postby DrGonzo » Mon Feb 29, 2016 11:00 am

I know the axle and the nut on the chain side are independent one another but are there some steps I should take in removing my rear wheel or some good tips to make this job a little easier?
I have new tires to mount and am waiting on a 16T engine sprocket so that when I have both I will install them at the same time and lube my chain, etc.
DrGonzo
 
Posts: 37
Joined: Mon Feb 08, 2016 2:33 pm

Re: Rear wheel removal?

Postby DAVID THOMPSON » Mon Feb 29, 2016 11:44 am

remove the clinch bolt on left side ,,on mine the axle is 18mm i think hold nut on right but do not move it
unless you need to adjust the chain
wheel then comes off like a bike with a drive shaft
do watch where all the spacers go :smt023

dave
Dave 2002 MZ RT125+1995 Saxon Tour(500cc)
1997 MZ 660 Traveller+6/13/09 WV USA
"IN the end times the IDIOTS will be in charge
of everything"
"I like the road less traveled if it's PAVED!"
wd8cyv at yahoo dot com
User avatar
DAVID THOMPSON
Moderator
 
Posts: 5149
Joined: Sun Nov 23, 2003 11:01 am
Location: Parkersburg, West Virginia USA .questions answered MZ 95 up, BMW 1953 to 1979 and ham radio WD8CYV

Re: Rear wheel removal?

Postby DrGonzo » Mon Feb 29, 2016 11:48 am

Cool, that's what I needed to know. Thanks.
DrGonzo
 
Posts: 37
Joined: Mon Feb 08, 2016 2:33 pm


Return to 500 cc

Who is online

Users browsing this forum: No registered users and 1 guest